rondzingen van externe fx op analoge tafel

Lennox

work in progress
Lid sinds
19 november 2005
Berichten
1.829
ik ben weer terug naar een analoge tafel een tascam m2600 en wil hier externe fx op aansluiten van een kurzweil ksp8. Die tascam heeft 8 send/aux receive

Logiserwijs sluit ik send 1 & 2 op de kurzweil in 1 & 2 en kurzweil uit 1 & 2 op aux receive 1 & 2.

Het lukt ik krijg fx maar ik kan de fx niet harder laten klinken zonder dat hij bij het minste geringste gaat rondzingen. Hij krijgt dus ergens een signaal terug een soort loop.

Uiteraard heb ik aardig wat uitgeprobeerd maar wat zie ik nu over het hoofd??? :erm:
 
Ik ken de tafel niet maar als ik in de SOS review kijk ( http://www.soundonsound.com/sos/1994_articles/aug94/tascamm2600.html ) kon het wel een hier zitten:

When you finally get down to the controls, you'll find the layout is clear and most are self-explanatory, apart from the Aux Send section. All six sends (two stereo, four mono) have their own Level control, but the two stereo sends also have a Split button. When Split is down they work normally, but when Split is up, Aux 1/2 and 3/4 are combined to form a single stereo cue mix which can be accessed both by the Cue and Monitor signal paths. Similarly, when these sends are switched to post-fade operation for use as effects sends, they may still be linked, thus enabling one stereo effects unit to be fed from both main Channel and Monitor signal paths. A L-R Cue button enables the main stereo mix to be added into the cue system via Sends 1 and 2, which is a useful way to feed the performers a quick monitor mix based on what's already set up on the studio monitors.
 
Ik vermoed dat je master mix signaal ook naar de send mix bus gaat. Als je je channel aux send dicht heb, komt er dan nog signaal in de Kurzweil?
 
Heeft die Kurzweil een DRY/WET regelaar ?
Als je een FX over aux send en return gebruikt mag je alleen WET terugsturen.
 
Back
Top