Steiner "breath/bite-to-CV"

[dob]

Kreeg ik net via de post; had er nog nooit van gehoord:

Its truly amazing I! quote"

This is an analog voltage controlled filter with the voltage control coming from three sources: breath, bite, and the foam rubber pad on the unit labeled "TM"- Touch Modulation. You blow into the connected tube and the filter opens and closes relative to breath pressure. The filter can oscillate and there are internal trim pots to adjust things. Breath can be output as a 0 to 10VDC signal for controlling synths. The "bite" control outputs a smaller voltage as you bite the second, sealed tube. You wiggle or rock your finger on the TM pad, and it outputs just enough voltage for expressive vibrato control and bend effects. It also outputs trigger voltages from the breath input (both positive and negative going triggers), so you can trigger most synth envelopes. It has Separate CV outputs for breath, bite, and the TM sensor. Has sensitivity control adjustments. 4 LEDs show breath amount and trigger states.

It makes analog synths incredibly expressive and of course you can route the cv anywhere as well as using the onboard filter.

 

[dob]

misschien heeft crumar er ook wat mee van doen

http://www.sonicstate.com/synth/_inc/picview.cfm?synthid=838

 

[JohnnyBusca]

Er staan een boel van dit soort bakkies van mark glinsky op ebay te koop. Ik ken ze verder ook niet.

 

[analogicbear]

Re: Steiner "breath/bite-to-CV"

Origineel geplaatst door dob
Kreeg ik net via de post; had er nog nooit van gehoord:

Ziet er wel relax uit dit van Steiner ik ben gek op dit soort doosjes en benieuwd hoe dhet filter klinkt.