Wat dacht je hiervan 
http://www.stucki.com/krhen/downloads/aurora/
- Take one Andromeda, lightly used (but out of warranty - very important!)
- Add one black on blue BETA Panel - because the pre-production beta panels were lacking the Pre- and Post-Filter Mix VIEW buttons, either the buttoncaps must be pulled off of the switches on the PCBs OR two holes need to be carefully drilled through the panel to accomodate. I drilled the holes after measuring about fifteen times each.
- Tilt that panel at approx. the same slope as the Korg MS-20. Requires the extending of a couple of ribbon cables inside, and some pop-rivetted braces. Not too hard.
- Custom wood endcheeks of nice Oak, plus a wood accent over the keyboard. I chose to go with thick, high quality wood to make Aurora more of a beast.
- Replace all green LEDs with red high-intensity ones. This also required changing some resistor values to increase the brightness.
- Replace the LCD with a Hantronix Blue-on-White display. Also, some resistor changes are needed.
- Have a very agreeable Alesis burn a custom Boot EPROM with the custom-designed bootup screen.
- Build a custom top panel, complete with several additional controls (two joysticks, several switches and knobs) as well as a full 16-channel mixer with level and pan per channel, one for each of the 16 individual outs on the Andromeda.
http://www.stucki.com/krhen/downloads/aurora/
- Take one Andromeda, lightly used (but out of warranty - very important!)
- Add one black on blue BETA Panel - because the pre-production beta panels were lacking the Pre- and Post-Filter Mix VIEW buttons, either the buttoncaps must be pulled off of the switches on the PCBs OR two holes need to be carefully drilled through the panel to accomodate. I drilled the holes after measuring about fifteen times each.
- Tilt that panel at approx. the same slope as the Korg MS-20. Requires the extending of a couple of ribbon cables inside, and some pop-rivetted braces. Not too hard.
- Custom wood endcheeks of nice Oak, plus a wood accent over the keyboard. I chose to go with thick, high quality wood to make Aurora more of a beast.
- Replace all green LEDs with red high-intensity ones. This also required changing some resistor values to increase the brightness.
- Replace the LCD with a Hantronix Blue-on-White display. Also, some resistor changes are needed.
- Have a very agreeable Alesis burn a custom Boot EPROM with the custom-designed bootup screen.
- Build a custom top panel, complete with several additional controls (two joysticks, several switches and knobs) as well as a full 16-channel mixer with level and pan per channel, one for each of the 16 individual outs on the Andromeda.
