Door chronisch tijdgebrek verkoop ik mijn West Coast Mini Synth welke nog moet worden afgemaakt.
Wat er tot nu toe heb gedaan is:
* Installed and wired most pots to the panel, installed the leds, switches and jacks.
* Prepared some mounting bracket in order to get all the pcb's nicely stacked.
* Soldered one VCO board and cleaned it afterwards.
* Soldered one VCA board
All components are included (based on the partlist from CGS) and individually packed. Only quality components used, so 1% resistors all over, WIMA, Nichicon or Panasonic caps, precision IC sockets etc.
Some somments on the components used per module:
* For the VCO ans VCA there are LM394 clones (metal cans) from Erica synth (http://www.ericasynths.lv/en/shop/diy/diy-accessories/as394-matched-t ransistors/)
* For the tempco's, big and good quality KRL's are included.
* The FET for the VCO is the Central 2N4391.
* Knobs are included, some nice Davies (1900 & 1913) from Thonk.
Prijs hier is 200 euro
Groetjes,
Jop
Wat er tot nu toe heb gedaan is:
* Installed and wired most pots to the panel, installed the leds, switches and jacks.
* Prepared some mounting bracket in order to get all the pcb's nicely stacked.
* Soldered one VCO board and cleaned it afterwards.
* Soldered one VCA board
All components are included (based on the partlist from CGS) and individually packed. Only quality components used, so 1% resistors all over, WIMA, Nichicon or Panasonic caps, precision IC sockets etc.
Some somments on the components used per module:
* For the VCO ans VCA there are LM394 clones (metal cans) from Erica synth (http://www.ericasynths.lv/en/shop/diy/diy-accessories/as394-matched-t ransistors/)
* For the tempco's, big and good quality KRL's are included.
* The FET for the VCO is the Central 2N4391.
* Knobs are included, some nice Davies (1900 & 1913) from Thonk.
Prijs hier is 200 euro
Groetjes,
Jop
