dynamic effect

bizz_rubain

DEN rubain
Lid sinds
11 februari 2008
Berichten
3
hallo ,

kan er mij iemand juist uitleggen hoe een dynamic effect werkt ?
het dynamic effect van de tc electronics d-two

greetzz
 
http://www.harmony-central.com/Reviews/TCElectronics/003.html :

The D-Two can operate in three delay modes: Traditional, in which a feedback loop is used to create delay repeats; Straight, where a multi-tap scheme lets you specify the exact number of repeats; and the highly expressive Rhythm, in which the delay will play your tapped-in rhythm.

You can sweeten the delayed signal with up to six effects. These are Spatial, which widens the stereo image; Filter, which applies a high- and low-cut filter to both the delayed signal and the source material; Chorus; PingPong, which pans the delays (not available in Traditional mode); Dynamic, where the delay output level is affected by the input level; and Reverse, which reverses delay repeats in several selectable combinations. Although each effect offers a few editable parameters, these effects can only work in tandem with delay -- the D-Two is not a multi-effects processor in the traditional sense.

Like the M-One, the D-Two is very simple to navigate thanks to a logical front panel that puts hardware control of delay time and feedback at your fingertips. While you'll need to spend more time with the D-Two's manual than you would with the M-One, it's still remarkably easy to use, thanks to the dedicated buttons and data-wheel for delay time and feedback amount. Each of the add-on effects has its own front panel button. Click a button once to activate or deactivate the effect -- twice to edit the effect's parameters.
 
oké maar ik dacht dat iemand me dit kon uitleggen in het nederlands :halleluja

Veel manuals zijn enkel in vreemde talen (Engels-Duits-Frans etc.).
Ik kan je dus warm aanbevelen Engels te leren, anders kom je met je apparatuur niet ver.

En/of een cursus geluids(opname) techniek volgen in de buurt. Daar leer je de basis van de apparatuur. Als je er één begrijpt, begrijp je de meeste wel. En als je de hardware techniek onder de knie hebt, snap je ook bijna meteen hoe het in software werkt. Daar ontbreekt het tegenwoordig ook nog wel eens aan (hoewel jij natuurlijk de vraag over hardware stelt).

Suc6
 
oké maar ik dacht dat iemand me dit kon uitleggen in het nederlands :halleluja

Dynamic, where the delay output level is affected by the input level;

Basicly zit er gewoon een heel simpel compressie algoritme in de D-Two. Compressie is een dynamisch "effect" (het is namelijk niet echt een effect) dat afhankelijk van de ingestelde treshold het ingangssignaal boven deze treshold met een bepaalde factor (ratio) verlaagt.

Of dit uiteindelijk gewoon een compressie over een delay algoritme is of juist een gecombineerd algoritme weet ik niet. Ik vermoed het eerste maar kan het fout hebben.
 
Back
Top