Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
5 cm

laat mono wat suggesties doen ,...Origineel geplaatst door mono-poly
Uhm alles semi modular zou koel zijjn hoor.
Dat je de burst envelopes kan patchen op je ms20
De Wasp filters ook ergens anders in kan gebruiken.
![]()


The Pixie design already caters for an external input signal on Mixer 1 (which feeds in to the filters) and for a control voltage in to the filter controller itself. Additional inputs can be added although, of course, the controls for these would not be covered by the existing panel design.
It is possible to build the Pixie in a modular format but you need to be aware that the design of the original WASP did not require or consider interfacing to other external modules other than through the LINK (sequencer) input. Consequently, many of the signal levels within the WASP (and hence the Pixie) are not ideal, in their raw form, for interfacing with external systems. However, of course, it is quite possible to add additional opamp circuitry to buffer, level-shift and scale any of the signals so that they would interface with other systems more easily. The Pixie design does have most of the input and output points available either by intercepting the relevant panel control (for instance by inserting a jack in to the wiper of, say, DCO1 Level pot, this input would become available as a `Mixer Input' and similarly a `DCO output'. Other points are provided with jumpers on the board so that signals can be diverted, bypassed or replaced as the builder sees fit.
I have had a number of requests for a `modular version' and will have to sit and down and work out exactly what would be needed to achieve this.
I have attached a drawing detailing the dimensions of the panel and the location of the 4 fixing holes. An case should, ideally, allow for at least a 6mm support lip on the 2 sides and around 4mm on the top and bottom edges. This will give good support all-round to the panel with the wider sides taking a fixing nut of some form.
Origineel geplaatst door electricman
Je moet douane (invoer) rechten betalen.
Dit is 3,2 % maar je moet ook daarover BTW betalen.
Je moet de vollgende tariccode (goederencode) opgeven aan de gene die je synth inklaart:
92.07.105000
![]()
anoniempje en ...
en ja asdat kan bv verstuuren voor helft waarde ,..weet niet goed hoe dat qa vertrouwens kwestie enso werkt ...helft vooruit betalen ,..kijkasje dan idd erover moet taxxen en invoeren ist te doen ,....de xtra centen
